Supplying Power
Charge the Battery Pack on the AC Adaptor
Before Use
1Connect
POWER Lamp
2Attach
and plug in the Power Cord as shown. � POWER Lamp will light. � Remove the DC Cable, if attached, from the adaptor. the Battery as shown to charge. � CHARGE Lamp lights up. It goes out when charging is complete (approx. 1 hour). Expect approx. 1 hour 50 minutes of operation (using EVF) when fully charged. the Battery. Slide the Battery out and then lift up.
CHARGE Lamp
3Remove
Note About the Flashing of the CHARGE Lamp
� Charge the Battery within an ambient temperature range of 10 °C (50 °F) and 30 °C (86 °F). � If charging is done in extreme low or high temperatures, Battery charge time increases. CHARGE Lamp flashes when... � The Battery is being charged, but charging is taking longer than normal. � Charging is not possible. Remove the Battery once, wait a short time, then re-attach it for charging.
Insert the Battery Pack
Remove the Battery Pack
1 3 2 1 2
BATT RELEASE
1
Insert the Battery Pack and slide it up until it locks with a click.
1 2
Tilt Viewfinder upward. Remove the Battery Pack and slide the Battery downward while sliding the BATT RELEASE.
