|
|
|
Kategorie
|
|
Informacje
|
|
Polecamy
|
|
|
 |
|
|
Dla tego produktu nie napisano jeszcze recenzji!
 ;
Dobrej jakości skan - wkońcu mogłem poznać wszystkie funkcje tego odtwarzacza - polecam .
;
Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Appendices
� Set the counter display to �FreeTime� and check the amount of recordable time. (�p.56) Is the bounce setting (�BOUNCE�) appropriate? (�p.29) � If the bounce setting (�BOUNCE�) is set to �CONV,� the recording will be created as a new song. (�p.51) Master/�nal effect: Adjust the effect parameters so that �CLIP� for the master L/R track does not light.
Effect does not apply
Tuner mode may have been selected. � The effect will be bypassed (off) when the tuner is selected. Is the master volume of the effect program set to �0� or close to �0�? � Press the [EFFECT] key, then press the [CURSOR] right key several times to display �ProgMVol,� and
Can�t record two tracks simultaneously
The �EFFECT ASSIGN� (effect insert location) may have been set to �GUITAR.� � If this is set to �GUITAR,� only one track can be recorded simultaneously.
Is the [TRIM] knob raised to an appropriate level? � If the [TRIM] setting is too high the sound will distort; if it is too low, noise will be heard. (�p.18) If the effect input is distorted, make the following adjustments. Guitar/insert effect: Hold down the [SHIFT] key and press the [DISPLAY] key, and select the �PRE� setting for �DISPLAY.� Then use [TRIM] etc. to adjust the input volume as high as possible without allowing �CLIP� to light in the level meter. Master effect: Adjust the faders and send level so that �CLIP� for the master L/R track does not light.
Input sound or recorded sound contains noise or distortion
raise the volume setting. Is the [TRIM] knob raised to an appropriate level? � If the [TRIM] setting is too low, the effect may not be applied in some cases.
Guitar/insert effect does not apply
Is the effect insert location appropriate? � Hold down the [SHIFT] key and press the [EFFECT] key, and set �EFFECT ASSIGN� to �GUITAR� or �INSERT.� (�p.35) It is not possible to use a guitar/insert effect on a playback track.
Master effect does not apply
Is the effect insert location correct? � Hold down the [SHIFT] key and press the [EFFECT] key, and set �EFFECT ASSIGN� to �MASTER.� (�p.35) Is the send level from each track set to �0�or close to �0�? � Press the [MIXER] key, and use the [CURSOR] keys to raise the �Send-L� and �Send-R� send levels.
Final effect: Adjust the faders so that �CLIP� does not light for the master L/R track. If the effect output is distorted, make the following adjustments. Guitar/insert effect: Adjust the effect parameters and [TRIM] while listening to the sound.
85
|
|
|
> |
|
