worn out. Please see the "EXCHANGE THE FADER UNIT" section of this manual. uMASTER LEVELVOLUME �Adjusts the signal level outputs from MASTER OUT. iMASTER MUTE SWITCH �This is the switch which mutes the output sound signal from MASTER OUT jack of the rear panel. If you turn the switch on, the output will be muted.
oMONITOR SELECT SWITCH �This switch is used to select the way of monitoring from following. �PGM1･････ It allows you to hear input signal of PGM1. �MASTER ･･ It allows you to hear the signal of MASTER OUT. �PGM2･････ It allows you to hear input signal of PGM2.
SIDE
!0POWER SWITCH �Use to turn power on. �NOTE This switch should be turned on after you have turned off all input devices and before you turn on any devices attached to output. !1C.F. CURVE SWITCH �Select the cross fader curve. When this switch is slide to right side it gives a steep cross fader good for scratching and cutting. When sliding to the left side it gives a gentle cross fader good for long running mixes. !2PHONES LEVEL VOLUME �Adjusts the headphone monitor level. !3PHONES2 JACK�-MINI JACK(�3.5) Connect the headphones with a 1/8" mini headphone plug. �(the impedance of 8ohm to 600ohm) !4PHONES1 JACK�-PHONE JACK(�6.3) �Connect the headphones with a standard 1/4" stereo plug. (the impedance of 8ohm to 600ohm)
BOTTOM
!5I.F. REVERSE SWITCH �Reverses the action of the input fader by marking the zero point top instead of bottom. !6C.F. REVERSE SWITCH �Reverses the action of the cross fader by switching PGM1 and 2.
REAR PANEL
MODEL NO. QFO L
100V 50/60Hz 15W
R LINE 2 MASTER OUT LINE 1
MADE IN CHINA SERIAL NO.
18
17
18
19
REAR PANEL
!7MASTER OUT JACK �Connect to the line/AUX input of power amplifier/mixer. !8LINE INPUT JACK �Connect the equipment with line level output (-10dB or 0dB), such as CD players, tape decks, DATs, MDs, etc. The signal from line level equipment is fed to the PGM channels when Line input is selected. !9AC POWER CODE �Connect the AC power cord to suitable outlet. �NOTE This unit has been manufactured to fit strict quality and safety standards. PLEASE ENSURE that you use the correct power supply as shown on the rear panel of this device. FAILURE to do so many result in shock and/or serious damage to this unit and/or users.
