Adjust the level of the selected channel as desired.
3
Repeat the above steps 1 and 2 to adjust each channel level.
CH/LEVEL
� If the channel display disappears, start from the step 1 again.
Presetting and Calling the channel levels
� You can store the adjusted channel levels in the memory. If you change the channel levels and want to hear with preset levels, you can call them again. Presetting the channel levels
1
Perform the steps 1 to 3 in �Adjusting each channel level� on page 25~26 to adjust each channel level you want.
2
Press the SETUP button for more than 2 seconds, then it enters the setup mode. While displaying the setup mode, press this button short repeatedly until �P CALL� is displayed.
SETUP
MEMORY
3
While displaying �P CALL�, select �P MEMORY� with buttons below.
ADJUST
Confirm your decision.
4
DECODING TUNE MODE
TUNING/PRESET
�P CALL� : When calling the preset channel levels. �P MEMORY� : When storing the adjusted channel levels in the preset memory. Calling the channel levels
� The adjusted channel levels has now been stored in the preset memory. � When using this function with remote control unit, press OSD button and refer to page 38~40.
� Select �P CALL� with performing the above steps 2 to 4. � Then the current channel levels are changed to the preset ones.
