3 Press INPUT repeatedly to select the
input connector.
To record through Turn on the indicator
You can start recording from the end of the existing material. Before recording, see �Notes on Recording� on page 16. When using the remote, set SELECT to CDR. � After recording, you must finalize the disc. Until the disc is properly finalized, it cannot be played on any other machine. See �Finalizing a CD-R or CD-RW� on page 24.
OPEN/CLOSE
DIGITAL OPTICAL IN OPTICAL ANALOG IN ANALOG
To record the disc in DECK A, turn off �OPTICAL� or �ANALOG.�
4 Press REC z.
DECK B stands by for recording.
H
INPUT
5 Adjust the recording level, if necessary.
For details, see �Adjusting the Recording Level� on page 21.
6 Press H. 7 Start playing the sound source you
want to record.
Xx
REC z
To pause recording
SELECT
Press X. To resume recording, press the button again or press H.
Note
INPUT REC z
Whenever you pause recording, a new track number is added. For example, if you paused recording while recording on track 4, the track number increases by one and recording continues on the new track when recording is resumed.
H
To stop recording
x
X
Press x. �PMA Writing� appears while updating the information of the disc before stopping the recording.
Notes
1 Turn on the amplifier and the sound
source, and then select the sound source on the amplifier.
2 Press OPEN/CLOSE of DECK B and
place a recordable CD-R or CD-RW on DECK B. Press OPEN/CLOSE again to close the disc tray.
� If you press REC z during recording, you can add a track (page 22). The track must be longer than 4 seconds. � This unit uses the Serial Copy Management System, which allows only first-generation digital copies to be made of premastered software via the unit�s digital input. Therefore you may not be able to record a CD-R or CD-RW digitally through OPTICAL IN, depending on the content being recorded.
