SONY RCDW3
Instrukcja Obsługi

Erasing a single track of CD-RW disc
You can erase one track on a CD-RW at a time. This process starts with the last track on the disc. Please note that before erasing a track, you must unfinalize the disc. If the disc is not unfinalized, follow the instructions of �Unfinalizing a CD-RW disc� (page 20). When using the remote, set SELECT to CDR for operations on DECK B.

Erasing an Entire CD-RW disc
Erasing the entire contents of a CD-RW disc is easy, and it does not matter whether the disc has been unfinalized or not. When using the remote, set SELECT to CDR for operations on DECK B.

ERASE

ERASE

1 Press ERASE twice until �DISC ERASE�
appears in the front panel display.

1 Press the ERASE button.
The �LAST TR ERASE� indicator will begin to flash, and the PLAY, PAUSE, and REC indicators light up for about 8 seconds. Erasing enters in standby mode.

The �DISC ERASE� indicator will begin to flash, and the PLAY, PAUSE, and REC indicators light up for about 8 seconds. Entire disc erasing enters in the standby mode.

2 Press H while �LAST TR ERASE� is
flashing.

2 Press H while �DISC ERASE� is
flashing.

The last track erasing starts. During the last track erasing, �LAST ERASE� appears in the display. When this process is finished, the total track number and the total playing time appears in the display.
Notes

Entire disc erasing starts. During erasing, �DISC ERASE� appears in the front panel display. When this process is finished, �00.00� appears in the display.
Notes

� Once entire disc erasing process starts, you cannot stop the erasing in the middle of the process. � Do not turn off the recorder or disconnect the recorder from the power source in the middle of the erasing process.

� The TOC (red) indicator appears on the front panel display if the disc you put in the DECK B has not been finalized. Check the indicator each time before erasing the last track of a disc. � Once erasing process starts, you cannot stop in the middle of the process. � Do not turn off the recorder or disconnect the recorder from the power source in the middle of the erasing process.

Recording on CDR

21