Applicare a pressione il coprifuga, tra apparecchiatura e mobile.
USE
Cleaning the interior
Before using the appliance for the first time, wash the interior and all internal accessories with lukewarm water and some neutral soap so as to remove the typical smell of a brand-new product, then dry thoroughly.
D724
Operation
Insert the plug into the wall socket. Open the refrigerator door and turn the thermostat knob, clockwise, beyond the �O� (STOP) position. The appliance will start to operate. To stop operation, simply turn the thermostat knob to position �O�
Do not use detergents or abrasive powders, as these will damage the finish.
Temperature regulation
The temperature is automatically regulated and can be increased to achieve a higher temperature (warmer) by rotating the thermostat knob toward lower settings or reduced (colder) rotating the knob towards higher settings. However, the exact setting should be chosen keeping in mind that the temperature inside the refrigerator depends on: B
50mm
Applicare i coperchietti (B) sulle alette dei coprifuga e nei fori per le cerniere.
¥ ¥ ¥ ¥
room temperature; how often the door is opened; the quantity of food stored; location of appliance.
D726
A medium setting is generally the most suitable. Important If the ambient temperature is high or the appliance is fully loaded, and the appliance is set to the lowest temperatures, it may run continuously causing frost to form on the rear wall. In this case the dial must be set to a higher temperature to allow automatic defrosting and therefore reduced energy consumption.
D
PR266
Separare i pezzi A, B, C, D come da figura
A
B
C
Fresh food refrigeration
To obtain the best performance: ¥ do not store warm food or evaporating liquids in the refrigerator; do cover or wrap the food, particularly if it has a strong flavour. Position food so that air can circulate freely round it.
Appoggiare la guida (A) sulla parte interna della porta del mobile sopra e sotto come indicato in figura e segnare la posizione dei fori esterni. Dopo aver preparato i fori fissare la guida con le viti in dotazione.
