Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 10 (kliknij aby zobaczyć)
g
d USAGE
Fig. 4-1 - Cord Retainer WARNING: Hook the extension cord around the cord retainer to help prevent disconnection or cable connection stress during usage. Always hold the product off the ground when starting. Fig. 4-2 - Mower Trimming For normal trimming, swing the head from side to side without tilting the string head. Keep the string head at same level for an even finish. Fig. 4-3 - Close Trimming Tilt the stringhead to the left for close trimming. Using the left side of the stringhead will also tend to eject the grass or debris away from the operator. Fig. 4-4 - Scalping The further the stringhead is tilted, the closer the cut. Take extra care for flying debris when doing this. Fig. 4-5 - Edging The head can be twisted to the vertical position to edge around lawns, flower beds or pathways for a neater finish. Hold the machine to your left to ensure debris is projected away from you. WARNING: Only cut with the tip of the line. This is the most effective way to cut. Take special care not to allow line to curl around mesh fencing or to rub hard against abrasive surfaces such as walls. This will cause excessive line wear or line breakage. Fig. 4-6 - Do not use the trimmer to �sweep� debris. Fig. 4-7 - Do not attempt to feed line bumping the head on the ground.
e ROUTINE MAINTENANCE
After usage, disconnect from the mains supply and clean dirt and debris from the cutter line area. This will prolong motor life by maintaining adequate airflow to cool the motor and ensures the �REX� line head continues to snap on and off smoothly. Inspect the cutter line head for parts that may be chipped, cracked or damaged as these could fly away and cause serious injury. Replace damaged parts immediately. Use only genuine Rex replacement parts. Any other maintenance work should be carried out by an authorised McCulloch Service Agent only. Check the product and cable regularly for visible signs of damage or wear. Check that all fasteners and moving parts are secure. Consult an Authorised Service Dealer if in doubt.
FAULT FINDING
If your trimmer will not start, check that all cables are connected and that the mains power is on. If it still does not work, check the fuse. If you have tried the above and your trimmer still does not work, take it to your nearest Authorised Service Dealer.
f UNWANTED PRODUCTS AND THE ENVIRONMENT
Should you find one day that your product needs replacement, or is of no further use to you, think of the protection of the environment. McCulloch Service Centres will accept your old products and will dispose of them in an environmentally safe way.
