Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 2 (kliknij aby zobaczyć)
Reprogramming Oven Settings Programming Heating Times Oven must be programmed to accept power and Power Levels
levels before programming new START pads. Using the control panel template as a guide, follow these steps to program the pita warmer oven control. See last page for template. 1. Cut out control panel picture to place over pita warmer control panel when programming START pads. 2. Place control picture over control panel so �1� pad is centered over HEAT 1 BAG �START� pad and tape into place. 3. Open oven door and press RESET pad. Leave door open during programming process. � If door is closed or RESET pad is pressed again before programming sequence is finished, oven exits programming mode. 4. Press and hold pad 1 for approximately 15 seconds. � After 15 seconds, signal sounds. Display shows �P�. 5. Press Hidden Pad. Using the control panel template as a guide, follow these steps to program the new START pads located under pads 4 and 5 of the template control panel. 1. Open oven door and press RESET pad. Leave door open during programming process. � If door is closed or RESET pad is pressed again before programming sequence is finished, oven exits programming mode. 2. Press and hold pad 1 for approximately 15 seconds. � After 15 seconds, signal sounds. Display shows �P� indicating programming mode. 3. Press number 4 pad.
� Display shows dd:dd4 to indicate that pad 4 is disabled. 4. Press Hidden Pad.
0p : 10
� Displays shows �OP:10�. � �OP� represents optional program mode. 6. Press START pad 5 times until oven shows �OP:61� in the display.
� Time and pad number display. 5. Press 1, 0, and 0 pad to enter heating time. 6. Press MEDIUM 50% pad to enter power level.
WARM
0p : 61
7. Press 0 pad.
0p : 60
� Displays shows �OP:60�. 8. Press START pad to save changes. � Display shows �OP:73� after START pad is pressed. You have now completed programming pad 4 9. Press RESET pad or close oven door to exit for 1 minute at 50% power and 30 seconds at programming mode. 2 100% power.
7. Press TIME ENTRY pad. 8. Press 3 and 0 pad to enter second stage heating time. 9. Press START pad to save new heating times in oven memory for pad 4.
