WHIRLPOOL RH0500RAW00
Instrukcja Obsługi

Choosing

the proper

location

Read the following items before choosing the location for the freezer. See �Completing the installation� below before sliding freezer into place. 1. Pick a safe place, indoors, away from flammables such as gasoline. 2. Check the strength of the floor. It should hold the weight of a fully loaded freezer. 3. Allow at least 3 inches (7.5 cm) of air space on both sides of the freezer and 2 inches (5 cm) between the back of the freezer and the wall. Leave room above the freezer to open the lid. 4. It should not be necessary to remove the lid during installation. If, for any reason, the hinges need adjustment, see the label on the back of your freezer and contact an authorized Roper service company. Do not cover the freezer with items such as blankets, sheets, tablecloths, etc. This reduces air circulation.
NOTE:

Room to open Ild

2 inches at back

Completing

the installation

Level the freezer from side to side and front to back so that the lid will seal properly. Use shim(s) to level the freezer if necessary.

Installing
(on some

the defrost

drain cover

models)

1. Remove defrost drain cover from the

literature package. 2. Push drain cover into drain hole as illustrated.

6