|
|
|
Kategorie
|
|
Informacje
|
|
Polecamy
|
|
|
 |
|
|
Dla tego produktu nie napisano jeszcze recenzji!
 ;
Dobrej jakości skan - wkońcu mogłem poznać wszystkie funkcje tego odtwarzacza - polecam .
;
Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
MAINTENANCE
Adjustment of the cutting unit�s parallelism for the Rider 11 Bio and Rider 13 Bio
1. Check the tyre air pressure. It should be 60 kPa (0,6 kp/cm2). 2. Dismantle the front hood and right-hand fender as described on page 20-21. 3. Vertical adjustment of the cutting unit is made with the adjusting nuts on the back edge of the lift-strut. 4. Raise the cutting unit at the front edge by shortening the lift-strut. Lower the cutting unit at the front edge by lengthening the lift-strut. 5. Tighten the nuts against each other after the adjustment. 6. On completion of the adjustment the unit�s parallelism should be re-checked. Fit the right-hand fender and the front hood.
2
Adjusting the alignment of the cutting unit for the Rider 11 Bio and Rider 13 Bio
1. Check the tyre air pressure. It should be 60 kPa (0,6 kp/cm2). 2. Remove the front hood and right-hand fender as described on page 20-21. 3. Unscrew the nut (1) from the parallel strut. Remove the clip (2) and the parallel strut. 4. Turn the fork anti-clockwise to lower the rear edge of the hood, or clockwise to raise the rear edge of the hood. 5. Once adjustment is complete, refit the parallel strut and clip and tighten the nut. 6. Recheck the alignment of the cutting unit after adjustment. 7. Refit the right-hand fender and hood.
30 � English
|
|
|
> |
|
