MOUNTING INSTRUCTIONS
RM2351-2354
We recommend to mount the panel on the door before the refrigerator is installed in the enclosure. To mount the panel, follow these steps: 1. Slide the panel from the bottom of the door into the grooves on the vertical edges of the door . 2. Push the panel upwards. 3. Put the two plastic panel stops (from the parts bag) in the two holes at the lower door frame. 4. Put the decoration strip across the door and fasten it with three screws (from the parts bag).
Snap in
To mount the panel, follow these steps: 1. Open the door 90 degrees. 2. On new refrigerators, the decoration strip are taped inside the door; if installed on the door, remove the door decoration strip (2) by gently pushing the four tabs away with a �at blade screwdriver (1). 3. Insert the vertical edges into the grooves of the door frame (3). 4. Push the panel downwards so that the lower horizontal edge of the panel (4) is �tted into the bottom grove (5). 5. Snap in the decoration strip (2).
1
2
RM2451-2454-2551-2554-2652-2662- 2663-28522862 & NDR1062
With screws
To mount the panel, follow these steps: 1. Open the door 90 degrees. 2. On new refrigerators, the decoration strip is taped inside the door; if installed on the door, remove the door decoration strip (2) by removing its three screws (1). 3. Insert the vertical edges into the grooves of the door frame (3). 4. Push the panel downwards so that the lower horizontal edge of the panel (4) is �tted into the bottom grove (5). 5. Put the decoration strip across the door so that the gap is covered. Secure the decoration strip with the three screws removed in step 2.
2
1 2
1
1
1
1
1
3
3
4
5
REFRIGERATOR REMOVAL
Before removing the refrigerator: � Verify that the AC and DC voltage leads are disconnected. � Shut off the gas supply. � Disconnect the gas supply line at the rear of the refrigerator. Always use a back up wrench when loosening and tightening connections. To remove the refrigerator, follow these steps: 1. Cap the gas supply line. 2. Loosen the screws anchoring the refrigerator to the enclosure. 3. Slide the refrigerator out of the compartment. Replacement is the reverse of removal. When reinstalling the refrigerator, make sure the sealing strips are properly positioned. Check all connections for gas leaks. - 10 -
