|
|
|
Kategorie
|
|
Informacje
|
|
Polecamy
|
|
|
 |
|
|
Dla tego produktu nie napisano jeszcze recenzji!
 ;
Dobrej jakości skan - wkońcu mogłem poznać wszystkie funkcje tego odtwarzacza - polecam .
;
Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
If the memory of the remote is already full, the USE MODE button flashes 8 times in quick succession and the remote automatically exits the learning mode.
Selecting the mode of the remote
You can switch the command mode (AV1 or AV2) of the remote. If the command mode of the receiver and the remote is different, you cannot use the remote to operate the receiver.
6
Tip
Repeat steps 1 through 5 to program up to 10 IR codes.
If programming is unsuccessful, check the following: � If the USE MODE button does not light up in step 1, the batteries are weak. Replace both batteries. � If the USE MODE button lights 4 times in quick succession in step 3, an error has occurred. Start again from step 1.
1 2 3
Press ?/1 while holding down USE MODE. Move the easy scroll key to select �MAIN�, then press the key to enter the selection. Move the easy scroll key to select �AV1� or �AV2�, then press the key to enter the selection.
To cancel programming
Press USE MODE during any step. The remote automatically exits the macro setting mode.
To delay the output of an IR code
Start over from step 1. In step 3, press the easy scroll key lightly (for less than 2 seconds). A 1 second delay is programmed. The USE MODE button lights twice slowly, then the remote automatically exits the macro setting mode.
The USE MODE button lights once (or twice for AV2), then the command mode switches.
To set the 2nd zone mode (North American models only)
You can use the remote to select the input for the 2nd zone. You can use the easy scroll key only for the 2nd zone.
To clear the programmed IR codes
Clear each macro step individually. In step 3, press the easy scroll key for more than 2 seconds. The IR code is cleared. The USE MODE button lights twice slowly, then the remote automatically exits the macro setting mode.
1 2
Press ?/1 while holding down USE MODE. Move the easy scroll key to select �2ND�, then press the key to enter the selection.
The USE MODE button lights once, then the command mode switches.
To start macro play
Move the easy scroll key to select �M1� or �M2�, then press the key to enter the selection
Note
To reset the remote to factory settings
Press ?/1, AV ?/1, and MASTER VOL � at the same time. The USE MODE button lights 3 times, then goes off.
If the Macro Play function does not work properly, program a delay between each operation. See �To delay the output of an IR code�.
14GB
|
|
|
> |
|
