Schematy są ale można wysilić się i zrobić kolorowy skan i o większej rozdzielczości. Wtedy schematy płytek będą czytelniejsze. Całość super jako wartość merytoryczna. Wszystkie dane potrzebne do podłączenia różnego rodzajów urządzeń takich gramofon, CD itd.
jedyne do czego mogę mieć zastrzeżenie to jakość zdjęć zawartych w przesłanej instrukcji serwisowej ponieważ są fatalnej jakości, praktycznie nieczytelne. tak poza tym jestem zadowolony to jest to czego szukałem.
Tekstowy podgląd strony 9 (kliknij aby zobaczyć)
SECTION 4 DIAGRAMS
Note on Schematic Diagram: � All capacitors are in µF unless otherwise noted. pF: µµF 50 WV or less are not indicated except for electrolytics and tantalums. � All resistors are in � and 1/ W or less unless otherwise specified.
4
RM-NX7000
Note on Printed Wiring Board: � X : parts extracted from the component side. � Y : parts extracted from the conductor side. � : Pattern from the side which enables seeing. (The other layers' patterns are not indicated.) Caution: Pattern face side: (Side B) Parts face side: (Side A) Parts on the pattern face side seen from the pattern face are indicated. Parts on the parts face side seen from the parts face are indicated.
� % : indicates tolerance. � C : panel designation. � A : B+ Line. � Power voltage is dc 4.5V and fed with regulated dc power supply from extermal power voltage jack. � Voltages and waveforms are dc with respect to ground under nosignal conditions. no mark : POWER ON � Voltages are taken with a VOM (Input impedance 10 M�). Voltage variations may be noted due to normal production tolerances. � Waveforms are taken with a oscilloscope. Voltage variations may be noted due to normal production tolerances. � Circled numbers refer to waveforms.
� Main boards is six-layer pritnted board. However, the patterns of layer 2 to 5 have not been included in this diagrams.
� IC1 (microcomputer) and IC7 (flash RAM) on Main board cannot be replaced individually. Replace it with Main board assembly for service.
� IC1 (microcomputer) and IC7 (flash RAM) on Main board cannot be replaced individually. Replace it with Main board assembly for service. * The voltage and waveform of CSP (chip size package) cannot be measured, because its lead layout is different form that of conventional IC.