ROLAND RMP-5
Instrukcja Obsługi

Appendices

Replacing the Head
If the head has been damaged or no longer maintains correct tension, replace it. To order replacement heads (#03891812 RMP-3 PAD HEAD(MESH HEAD) <CM-2208-RN>), contact the retailer from whom you purchased the RMP-5 or the nearest Roland Service Center. The MH-8 Mesh Head is not compatible and cannot be used.

Replacing the Head
When replacing or tuning, use the included tuning key.
fig.HeadChange

1. Remove all tuning bolts. Gradually loosen each one in order, turning them counterclockwise. * Do not lose the tuning bolts. 2. Open the case, and then remove the old head. 3. Place the new head in the case. 4. Securely close the case. 5. Attach all eight tuning bolts. 6. Adjust the tension of the head. Refer to �Adjusting the Head Tension� (p. 7).

27