SONY RM-VJ1
Instrukcja Serwisowa

2-7. DISCONNECTING/CONNECTING THE FLEXIBLE CARD WIRE
The three flexible card wires are used as follows: Take care not to break the flexible card wire. This shorten the wire life. . Between DR-395 and DU-35 . Between LCD monitor and DR-395 . Between Backlight and DR-395 : Q�ty 1 : Q�ty 1 : Q�ty 1

Disconnecting
1. Turn off the power of the unit. Type A (between the DR-395 board and the DU-35 board, and the LCD monitor and the DR-395 board) 2. Lift up the portion A in the direction of the arrow and disconnect the flexible card wire. Type B (between the backlight and the DR-395 board) 2. Slide portion B in the direction of the arrow and disconnect the flexible card wire.

Connecting
n . Be careful not to insert the flexible card wires obliquely. . Check that the conductive surface of the flexible card wire is not soiled with dust. Type A 1. Lift up the portion A in the direction of the arrow. Insert the flexible card wire as far as it will go into connector with the conductive surface of the wire put down. 2. Push down the portion A to secure the flexible card wire. Type B 1. Slide portion B in the direction of the arrow and insert the flexible card wire as far as it will go into connector with the conductive surface of the wire put down. 2. Slide portion B in the opposite direction of the arrow and lock each connector.

A

B

Conductive surface Type A

B Conductive surface Type B

RM-VJ1/VJ1P

2-7 (E)