When the terminal is pushed into the receptacle as far as it will go, the surface unit will fit into the reflector bowl.
3.
Hold the surface unit as level as possible with the terminal just started into the
Reflector bowls reflect heat back to the utensils on the surface units. They also help catch spills. When they are kept clean, they reflect heat better and look new longer. If a reflector bowl gets discolored, some of the utensils used may not be flat enough. Or some may be too large for the surface unit. In either case, some of the heat that is meant to go into or around a utensil goes down and heats the reflector bowl. This extra heat can discolor it.
4.
While pushing the surface unit terminal into the receptacle, lift a little on the edge of the unit nearest the receptacle.
USING THE SELF-CLEANING
CYCLE
The self-cleaning cycle uses very hlgh heat to burn away soil. Before you start, make sure you understand exactly how to use the cycle safely.
BEFORE YOU START
Clean areas that may not be cleaned during the cycle. Use hot water and detergent or a soapy steel-wool pad on... l the frame around the oven l the inside of the door, especially the part outside the oven seal. DO NOT try to clean the tlberglass seal. DO NOT move It or bend It. Remove any pots or pans you may have stored in the oven. They can�t stand the soil or grease. This will during the cleaning
