jedyne do czego mogę mieć zastrzeżenie to jakość zdjęć zawartych w przesłanej instrukcji serwisowej ponieważ są fatalnej jakości, praktycznie nieczytelne. tak poza tym jestem zadowolony to jest to czego szukałem.
Instrukcja jest OK. Schematy czytelne, opisane niektóre procedury.
Tekstowy podgląd strony 7 (kliknij aby zobaczyć)
RS-WP1WT
Removing the LCD board (See Fig.7 and 8)
LCD board
E
Prior to performing the following procedures, remove the rear panel assembly and the function switch board. 1. Remove the four screws E attaching the bracket. 2. Disconnect the card wire from connector CN421, CN422 and the wire from CN913 on the LCD board respectively. 3. Disconnect the wire from connector CN624 on the CD mechanism assembly. 4. Remove the two screws F attaching the LCD board (The LCD spare board and the LED board are still attached to the LCD board).
LCD board CN913
Bracket
E
Fig.7
F
CN421
Removing the headphone jack board (See Fig.9 and 10)
Prior to performing the following procedures, remove the rear panel assembly. 1. Remove the two screws G attaching the headphone jack board bracket. 2. Pull out the headphone jack board bracket and the headphone cover at the same time. 3. Remove the two screws H attaching the headphone jack board. 4. Disconnect the wire from connector CN711 on the headphone jack board.
