Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 56 (kliknij aby zobaczyć)
Using Effects (Effect Mode) the patch to use.
The new patch is called up immediately. HINT
When you select an empty patch, the indication "EMPTY" appears on the display. In this case, the sound does not change. processing. When this parameter is ON, the sound of pad 0 in pad bank 1/2 will not be changed by the REVERB effect. (The same applies if the pad send level is raised in kit mode.) For information on how to turn the KICKDRY parameter on and off, see the section "Editing effect patches".
6. Use the VALUE [+]/[-] keys to bring
up the indication "BS SEND" on the display.
This screen lets you adjust the send level of the bass program.
3. Press the [EDIT] key.
The [REVERB] key flashes and the patch edit screen appears.
EFFECT
ON
7. Use the VALUE [+]/[-] keys to adjust
the bass program send level.
4. Use the cursor left/right keys to
bring up the indication "DR SEND" on the display.
This screen lets you adjust the overall send level of the drum kit.
8. When the send level patch has been
adjusted, press the [EXIT] key.
The RT-223 returns to the condition of step 1.
9. Save the current patch.
For information on how to save an effect patch, see page 58. NOTE
The send level setting for the drum kit/bass program is saved as part of the patch. If you switch to another patch without storing the edited patch �rst, the edit contents will be lost.
DR SEND
5
Drum kit send level
HINT
You can change the send level for each drum/percussion sound separately. To do this, adjust the send level for each pad in kit mode (� p. 51).
10.To temporarily bypass the REVERB
effect, press the [REVERB] key so
The REVERB effect is turned off, and the indication "BYPASS" is shown on the display. To turn the REVERB effect back on, press the [REVERB] key once more so that the key is lit.
5. Use the VALUE [+]/[-] keys to adjust
the drum kit send level. The send level can be adjusted in the range from 0 - 100.
HINT
that the key goes out.
11.To terminate the REVERB effect
setting, press the [EXIT] key.
The effect mode is terminated, and the RT-223 returns to the previous mode.
The REVERB effect comprises the KICKDRY parameter that excludes the s o u n d o f t h e k i c k d r u m f ro m e ff e c t
