JVC RV-DP100BK
Instrukcja Obsługi

You can preset up to 30 FM stations and up to 15 AM (MW/LW) stations. Note: Preset numbers may have been set to factory test frequencies prior to shipment. This is not a malfunction. You can preset the stations you want into memory by following one of the presetting methods below:

Manual Presetting ���������
TUNER
BAND FM MODE

REW

MULTI CONTROL

FF

Number key (For 2 seconds)

s Select a band (either AM or FM/FM-MODE) 1.
by pressing the TUNER BAND button.

s Press the 4 or ¢ button to tune in a sta2.
tion.

s Press the number key for more than two 3.
seconds to store in memory for the desired preset number.
The preset number blinks for four seconds and then the preset station for the preset number appears. Example: To preset the tuned station to the preset number 15, press +10 then 5 for more than two seconds. The display changes as follows.
(Tuned station) (For 2 seconds)

s Repeat above steps 1 to 3 for each station 4.
you want to store in memory with a preset number.
To change the preset stations, repeat the same steps as above to overwrite a new station.

Auto Presetting ����������
In each band, you can automatically preset FM-30, AM(MW/LW)15 stations. Preset numbers will be allocated as stations are found, starting from the lowest station and moving up the frequency.
TUNER
BAND FM MODE

AUTO PRESET

(For 2 seconds)

s Select a band (either AM or FM/FM-MODE) 1.
by pressing the TUNER BAND button.

s Press one of the following buttons. 2.
On the Unit: Press the PRESET TUNING button for more than two seconds. On the Remote Control: Press the AUTO PRESET button on the Remote Control for more than two seconds.

s Repeat steps 1 and 2 for the other band. 3.
s
If you want to change the preset stations, carry out the Manual Presetting for the desired preset numbers. CAUTION: To prevent the preset stations from being erased because of a power failure, etc., install memory backup batteries in the System. (See page 4.)

9

English

Presetting Stations