|
|
|
Kategorie
|
|
Informacje
|
|
Polecamy
|
|
|
 |
|
|
Dla tego produktu nie napisano jeszcze recenzji!
 ;
Dobrej jakości skan - wkońcu mogłem poznać wszystkie funkcje tego odtwarzacza - polecam .
;
Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Basic Settings
English
Crossover frequency
Small speakers cannot reproduce the bass sounds efficiently. If you use a small speaker in any position, this receiver automatically reallocates the bass sound elements assigned to the small speaker to the large speakers. To use this function properly, set this crossover frequency level according to the size of the small speaker connected. � If you have selected �LARGE� for all speakers, this function will not take effect (�CROSS OFF� appears).
Low frequency effect attenuator
If the bass sound is distorted while playing back software using Dolby Digital or DTS Digital Surround, follow the procedure below: � This function takes effect only when the subwoofer (LFE) signals come in, (with �SUBWOOFER� set to �YES�).
1
1
Press SETTING repeatedly until �CROSS (Crossover)� (with the current setting)* appears on the display.
SETTING
Press SETTING repeatedly until �LFE ATT (Low Frequency Effect Attenuator)� (with the current setting)* appears on the display.
setting, ��10dB� will be shown.
SETTING
* �0dB� is the initial setting. If you have already changed the
* �150HZ� is the initial setting. If you have already changed the setting, another frequency will be shown.
2
Press CONTROL UP 5/DOWN � to select the low frequency effect attenuator level.
� Each time you press the button, the setting alternates between �0dB� and ��10dB.� 0dB �10dB : Normally select this.
CONTROL DOWN UP
2
Press CONTROL UP 5/DOWN � to select the crossover frequency level you like to use.
� Each time you press the button, the crossover frequency level changes as follows:
80HZ 200HZ 100HZ 120HZ 150HZ
CONTROL DOWN UP
: Select this when the bass sound is distorted.
Note: Crossover frequency is not valid for the HEADPHONE mode.
Dynamic range compression
You can compress the dynamic range (difference between maximum sound and minimum sound) of the reproduced sound. This is useful when enjoying surround sound at night. � This function takes effect only when playing back a source using Dolby Digital.
1
Press SETTING repeatedly until �D. COMP (Dynamic range compression)� (with the current setting)* appears on the display.
SETTING
* �MID� is the initial setting. If you have already changed the setting, another setting will be shown.
2
Press CONTROL UP 5/DOWN � to select the appropriate compression level.
� Each time you press the button, the display changes as follows:
OFF MAX MID
CONTROL DOWN UP
OFF : Select this when you want to enjoy surround with its full dynamic range. (No effect applied.) MID : Select this when you want to reduce the dynamic range a little.
MAX : Select this when you want to apply the compression effect fully. (Useful at night.)
14
|
|
|
> |
|
