JVC RX-554RBK
Instrukcja Obsługi

English

Activating the Surround Sounds

Using the DAP Modes You can use five DAP modes � �Dance Club, Live Club, Hall, Pavilion, and Headphones.� These modes (except �Headphones�) require the front speakers and the rear speakers, but do not require a center speaker to enlarge the sound field. Among the DAP modes, �Headphones� is very special. It can create the same stereo sound as you listen through the speakers off air while listening to a source using headphones. So, you can feel as if you were not using the headphones and listening to music in a room.

On the front panel:
1. Press SURROUND so that the Control % / � / @ / # buttons work for selecting the surround/DAP/3DPHONIC modes. The lamp above the button lights up. 2. Press Control % / � until one of the DAP mode (�HEAD P,� �PAVILION,� �HALL,� �LIVE C,� or �DANCE C�) appears on the display. Each time you press the button, the surround/DAP/3DPHONIC modes change as follows:
Ex.
SURROUND

Note:
When one of the DAP modes is selected, the DAP indicator also lights up on the display.

PROLOGIC OFF

THEATER 3DACTION*

3CHLOGIC PAVILION*
(One of the five modes appears)

* As for the 3D-PHONIC modes (see page 27) and the DAP modes, one of the previously selected mode appears on the display. 3. Press Control @ / # until the DAP mode you want appears on the display. Each time you press the button, the DAP modes change as follows: HEAD P PAVILION

Note:
When changing the DAP modes to �PAVILION� or �HALL,� a reverberation sound comes out. This is because a long reverberation is applied to these two modes.

DANCE C
HEAD Phones* PAVILION HALL LIVE Club DANCE Club

LIVE C

HALL

Gives a spacious stereo effect when listening with headphones. Gives the spacious feeling of a pavilion with a high ceiling. Gives clear vocal and the feeling of a concert hall. Gives the feeling of a live music club with a low ceiling. Gives a throbbing bass beat.

* When you select �HEAD P,� you cannot go to the following steps. No adjustments can be made for �Headphones.�
ADJUST

4. Press ADJUST so that the Control % / � / @ / # buttons work for adjusting the selected mode. The lamp above the button lights up. 5. Press Control % / � until �� REAR +� appears on the display.

Note:
Once you have adjusted the DAP modes, the adjustment is memorized for each DAP mode.

29