JVC RX 6000VBK
Instrukcja Serwisowa

RX-6000VBK/RX-6008VBK/RX-6100VBK Removing each board in the front panel assembly (See Fig.17 to 20)
Prior to performing the following procedure, remove the top cover and the front panel. 1. Pull out the volume knob on the front side of the front panel and remove the nut attaching the volume board. 2. Remove the three screws N attaching the volume board on the back of the front panel and disconnect the harness from connector CN411 on the volume board. 3. Remove the ten screws O attaching the system control board and disconnect the harness from connector CN402 on the system control board. 4. Remove the six screws P attaching the operation switch board. Push each tab b of the four joints inward and detach the operation switch board to the front. 5. Remove the screw Q attaching the operation switch board.

Front panel assembly

Nut Volume knob

Fig.17

O

O

N
CN411

N

O

CN402

O
Fig.18

Volume board

System control board

P

Tab b

Tab b

P
Fig.19

P

Q

System control board

Fig.20

2-6