|
|
|
Kto jest w sklepie?
Sklep przegląda 6043 gości |
|
Kategorie
|
|
Informacje
|
|
Polecamy
|
|
|
 |
|
|
Dla tego produktu nie napisano jeszcze recenzji!
 ;
Dobrej jakości skan - wkońcu mogłem poznać wszystkie funkcje tego odtwarzacza - polecam .
;
Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Basic Settings
Some of the following settings are required after connecting and positioning your speakers in your listening room, while others will make operations easier.
Recording a Source
You can record any source playing through the receiver to a cassette deck (or a CD recorder) connected to the TAPE/CDR jacks and the VCR connected to the VCR jacks at the same time. While recording, you can listen to the selected sound source at whatever sound level you like without affecting the sound levels of the recording.
Setting the Subwoofer Information
Register whether you have connected a subwoofer or not. Before you start, remember... � There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 1 again.
On the front panel ONLY:
Note:
The output volume level, tone adjustment (see page 10), and DSP modes (see page 21) cannot affect the recording.
1. Press SETTING repeatedly until �SUBWOOFER� appears on the display.
The display changes to show the current setting.
T SETTING
Adjusting the Front Speaker Output Balance
If the sounds you hear from the front right and left speakers are unequal, you can adjust the speaker output balance. Once it has been adjusted, the receiver memorizes the adjustment. Before you start, remember... � There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 1 again.
2. Press CONTROL UP 5/DOWN � to register whether you have connected a subwoofer or not.
� Each time you press the button, the subwoofer setting alternates between �YES� and �NO.� YES: NO:
CONTROL DOWN UP
Select this when a subwoofer is used. up on the display (see page 8.) Select this when no subwoofer is used.
S.WFR
lights
On the front panel ONLY:
1. Press ADJUST repeatedly until �L/R BALANCE� appears on the display.
The display changes to show the current setting.
ADJUST SETTIN
Changing the Source Name
When you have connected the CD recorder to the TAPE/CDR jacks on the rear panel, change the source name shown on the display when you select the CD recorder as the source.
2. Press CONTROL UP 5/DOWN � to adjust the balance.
� Pressing CONTROL UP 5 decreases the left channel output from CNTR (Center) to �21. � Pressing CONTROL DOWN � decreases the right channel output from CNTR (Center) to �21.
CONTROL DOWN UP
On the front panel ONLY: When changing the source name from �TAPE� to �CDR�:
1. Press TAPE/CDR.
� Make sure �TAPE� appears on the display.
TAPE/CDR
SOURCE NAME
2. Press and hold SOURCE NAME (TAPE/CDR) until �ASSGN. CDR� appears on the display.
To change the source name from �CDR� to �TAPE,� repeat the same procedure above (in step 1, make sure �CDR�
appears on the display).
Note:
Without changing the source name, you can still use the connected components. However, there may be some inconvenience. � �TAPE� will appear on the display when you select the CD recorder. � You cannot use the digital input (see page 14) for the CD recorder. � You cannot use the COMPU LINK remote control system (see page 28) to operate the CD recorder.
11
|
|
|
> |
|
