|
|
|
Kategorie
|
|
Informacje
|
|
Polecamy
|
|
|
 |
|
|
Dla tego produktu nie napisano jeszcze recenzji!
English
Using the Surround Processor
Preparing for Surround Modes Once you have set the surround modes, you can use the same adjustments every time you want to activate the surround mode you want. The receiver memorizes surround adjustments for each mode.
On the front panel:
1. Press SURROUND so that the Control % / � / @ / # buttons work for selecting the Surround Processor mode. The lamp above the button lights up. 2. Press Control % / � to select one of the surround mode (�PROLOGIC,� �3CHLOGIC� or �THEATER�). Each time you press the button, the Surround Processor modes change as follows:
Ex.
SURROUND
Note:
When one of the surround modes is selected, the corresponding indicator lights up on the display.
PROLOGIC OFF
THEATER 3DACTION*
3CHLOGIC PAVILION*
PROLOGIC THEATER
3CHLOGIC OFF
Select this mode when you use a center speaker and rear speakers. Select this mode to watch a video source with Dolby Surround when you have connected the rear speakers (and a center speaker). This mode gives you the feeling of a movie theater. Select this mode when you use a center speaker without rear speakers. Select this to turn off the Surround Processor mode.
* You cannot select the 3D-PHONIC modes or the DAP modes in this step. For the 3D-PHONIC modes: see pages 23 and 24. For the DAP modes: see pages 25 and 27. 3. Press ADJUST so that the Control % / � / @ / # buttons work for adjusting the selected surround mode. The lamp above the button lights up. 4. Press Control % / � until �CNT MODE� (Center Mode) appears on the display.
ADJUST
Note:
If you have already set the center speaker size following the procedure described on page 19, you do not have to select the center mode in this procedure.
29
|
|
|
> |
|
