JVC RX-8010RBKE
Instrukcja Obsługi

Center Delay Time Setting
Register the delay time of the sound from the center speaker, comparing to that of the sound from the front speakers. If the distance from your listening point to the center speaker is equal to that to the front speakers, select 0 ms. As the distance to the center speaker becomes shorter, increase the delay time. � 1 msec increase (or decrease) in delay time corresponds to 30 cm decrease (or increase) in distance. � When shipped from the factory, the delay time is set to 0 ms. Left front speaker

Center speaker Right front speaker

3.0 m 2.7 m 2.4 m 2.1 m

On the front panel ONLY:

1. Press SETTING repeatedly until �CTR DELAY� (Center Delay) appears on the display.
The display changes to show the current setting.

CT SETTING

2. Press CONTROL UP 5/DOWN � to select the delay time of the center speaker output (from 0 ms to 5 ms).
Notes:

CONTROL DOWN UP

Left rear speaker

Right rear speaker

Ex.: In this case, set the center delay time to �1 ms� and the rear delay time to �2 ms.�

� Center delay time is not valid for the DVD MULTI playback mode. � You cannot adjust the center delay time when you have set �CTR SPK� to �NONE.�

Crossover Frequency Setting
Small speakers cannot reproduce the bass sound very well. So, if you have used a small speaker for any of the front, center, and rear channels, this receiver automatically reallocates the bass elements, originally assigned to the channel for which you have connected the small speaker, to another channel (for which you have connected the large speaker). To use this function properly, you need to set the crossover frequency level according to the size of the small speaker connected. � If you have selected �LARGE� for all speakers (see page 17), this function cannot be adjusted.

Rear Delay Time Setting
Register the delay time of the sound from the rear speakers, comparing to that of the sound from the front speakers. If the distance from your listening point to the rear speakers is equal to that to the front speakers, select 0 ms. As the distance to the rear speakers becomes shorter, increase the delay time. � 1 msec increase (or decrease) in delay time corresponds to 30 cm decrease (or increase) in distance. � When shipped from the factory, the delay time is set to 5 ms.

On the front panel ONLY:

On the front panel ONLY:

1. Press SETTING repeatedly until �REAR DELAY� appears on the display.
The display changes to show the current setting.

ECT SETTING

1. Press SETTING repeatedly until �CROSS OVER� appears on the display.

ECT SETTING

The display changes to show the current setting.
CONTROL DOWN UP

2. Press CONTROL UP 5/DOWN � to select the crossover frequency
CONTROL DOWN UP

2. Press CONTROL UP 5/DOWN � to select the delay time of the rear speaker output (from 0 ms to 15 ms).
Notes:

level according to the size of the small speaker connected.
� Each time you press the button, the display changes to show the following:

80Hz

100Hz

120Hz

� Rear delay time is not valid for the DVD MULTI playback mode. � You cannot adjust the rear delay time when you have set �REAR SPK� to �NONE.�

� Use the following comments as reference when adjusting. 80Hz: Select this when the cone speaker unit built in the speaker is about 12 cm. 100Hz: 120Hz: Select this when the cone speaker unit built in the speaker is about 10 cm. Select this when the cone speaker unit built in the speaker is about 8 cm.

Note:
Crossover frequency is not valid for the DVD MULTI playback, 5 CH /4 CH Stereo, 3D-PHONIC, and HEADPHONE DSP modes.

18