JVC RX-8010VBKJ
Instrukcja Obsługi

Using the DVD MULTI Playback Mode
This receiver provides the DVD MULTI playback mode for reproducing the analog discrete output mode of the DVD player. Before playing back a DVD, refer also to the manual supplied with the DVD player.

Activating the DVD MULTI Playback Mode
You can adjust the DVD MULTI playback mode while playing back a DVD using the analog discrete output mode on the DVD player. Once you have made adjustments, the receiver memorizes the adjustments until you change them. You also need to set the DVD player to the analog discrete output mode. Before you start, remember... � There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 3 again. � To adjust the front speaker output balance and subwoofer output level, see pages 16 and 17.

From the remote control:

1. Press DVD MULTI so that �DVD MULTI� appears on the display.
The DVD MULTI lamp on the front panel button lights up.

DVD MUILTI

Note:
When you select �DVD MULTI� as the source to play, the Surround and DSP modes are canceled, and the SURROUND ON/OFF and DSP MODE buttons do not work.

2. Select the analog discrete output mode on the DVD player, and start playing a DVD.
� Refer to the manual supplied with the DVD player.

On the front panel:

1. Press DVD MULTI so that �DVD MULTI� appears on the display.
The DVD MULTI lamp on the front panel button lights up.

DVD MULTI

If you need to make any adjustment, go to the following steps.

3. Press SOUND.
The 10 keys are activated for adjusting the sound.

SOUND

Note:
When you select �DVD MULTI� as the source to play, the Surround and DSP modes are canceled, and the SURROUND ON/OFF and DSP MODE buttons do not work.

4. Select the speaker you want to adjust.
� To select the center speaker level, press CENTER. �CTR� appears on the remote control display window. � To select the left rear speaker level, press REAR L. �REARL� appears on the remote control display window. � To select the right rear speaker level, press REAR R. �REARR� appears on the remote control display window.

2. Select the analog discrete output mode on the DVD player, and start playing a DVD.
� Refer to the manual supplied with the DVD player.

If you need to make any adjustment, go to the following steps.

�CENTER
9

�REAR L
0
FM MODE

�REAR R
+10
100+

3. Adjust the speaker output levels.
1) Press LEVEL ADJUST repeatedly until one of the following indications appears on the display. �CENTER�: To adjust the center speaker level. �REAR L�: To adjust the left rear speaker level. �REAR R�: To adjust the right rear speaker level. 2) Press CONTROL UP 5/DOWN � to adjust the selected speaker output level (from �10 dB to +10 dB). 3) Repeat 1) and 2) to adjust the other speaker output levels.
AL LEVEL ADJUST

5. Press LEVEL +/� to adjust the speaker output levels (from �10 dB to +10 dB). 6. Press SOUND.

+
�

�BAL L

CH/ LEVEL

�

�BAL R
SOUND

� To adjust other speaker output levels, then repeat
CONTROL DOWN UP

steps 4 and 5.

Notes:
� You cannot adjust the center tone level. � You cannot use the midnight mode for DVD MULTI playback mode (see page 13). � When using a pair of headphones, the sounds of front left and right are output from the headphones.

35