|
|
|
Kto jest w sklepie?
Sklep przegląda 5663 gości i
10 zarejestrowanych klientów |
|
Kategorie
|
|
Informacje
|
|
Polecamy
|
|
|
 |
|
|
Dla tego produktu nie napisano jeszcze recenzji!
 ;
jedyne do czego mogę mieć zastrzeżenie to jakość zdjęć zawartych w przesłanej instrukcji serwisowej ponieważ są fatalnej jakości, praktycznie nieczytelne. tak poza tym jestem zadowolony to jest to czego szukałem.
 ;
Wszystko w porządku.
Instrukcja czytelna i kompletna.
Dziękuję.
all right!
thank you.
;
Bardzo dobra instrukcja. Zawiera wszystko co potrzeba, polecam!
;
Instrukcja jest OK. Schematy czytelne, opisane niektóre procedury.
;
Instrukcja bardzo czytelna. zawiera co potrzeba. Polecam
RX-8022PSL
Removing the main board (See Fig.13 to 15)
Prior to performing the following procedure, remove the top cover.
Tie band
M
CN721 CN723
Tie band
M
1. Remove the card wire and cut off the tie bands.
Card wire
2. Disconnect the harness from the connector CN721, L CN723, CN813, CN814, CN831 and CN881 on the main board. Main board 3. Disconnect the harness from the connector CN722 on the Cch amp. board (see fig.5). 4. Disconnect the harness from the connector CN811 on the power trans1 board. 6. Remove the screw K, after removing the relay board if needed (see fig.11). 7. Remove the two screws L and the six screws M attaching the main board. 8. Remove the two screws N attaching the heat sink to the main board. 9. Disconnect the connector of each amp. board.
CN831 CN814 CN813
CN811 Power trans1 board CN722
K
L
CN881
Fig.13
Heat sink
N
Main board (reverse side)
Fig.14
Rch amp. board Lch amp. board Cch amp. board
Removing the each amp. board of Cch, Lch, Rch, RLch and RRch (See Fig.16)
Prior to performing the following procedure, remove the top cover and main board.
RLch amp. board RRch amp. board
Heat sink
Main board
1. Remove the two screws O attaching the Cch amp. board and remove the Cch amp. board. 2. Remove the two screws P attaching the Lch amp. board and remove the Lch amp. board. 3. Remove the two screws Q attaching the Rch amp. board and remove the Rch amp. board. 4. Remove the two screws R attaching the RLch amp. board and remove the SLch amp. board. 5. Remove the two screws S attaching the RRch amp. board and remove the SRch amp. board.
CN706 CN705 CN702 CN701 CN703
Fig.15
S(RRch)
Q(Rch)
Heat sink
O(Cch)
Removing the Heat sink
(See Fig.16)
T
T
Prior to performing the following procedure, remove the top cover, main board and each amp. board. 1. Remove the four screws T attaching the two brackets to the heat sink and remove the two brackets. 1-6
Bracket
R(RLch)
Fig.16
P(Lch)
Bracket
|
|
|
> |
|
