Cassettes
This unit is suitable for playing normal tapes, but high and metal position tapes will not be played to their full potential.
4
Adjust the volume.
231
4
To stop play Press [L/c STOP/EJECT]. (Unit is switched off.) To pause To rewind/ fast-forward Press [J PAUSE] during playback. To resume, press [J PAUSE]. Press [) REW/REV] (to rewind) or [( FF/CUE] (to fast-forward) in the stop mode.
To find a particular Press [) REW/REV] (to search backward) or spot [( FF/CUE] (to search forward) during playback. Play is resumed when the button is released.
Press [L/c STOP/EJECT] to open the deck and load a cassette.
Close deck by hand. Side to be played facing you
Exposed tape facing upward
3
Press [/ PLAY] to start play.
Unit comes on and play starts.
Recording
You can record radio broadcasts or CDs. Before recording � This unit is suitable for recording normal tapes, but it cannot record onto high and metal position tapes to their full potential and prior recordings will not be erased correctly. � The recording level is set automatically. � Take up the leader tape before proceeding.
3
Press [[
[/ PLAY] is also depressed with [[
] to start recording.
].
Recording starts (one side only). The CD also starts playing if in CD mode. To stop recording Press [L/c STOP/EJECT]. (The CD does not stop.) To stop recording temporarily Press [J PAUSE]. (The CD does not stop.) Press once again to resume recording. To record on the other side of the cassette Turn the cassette over and press [[ ]. If the CD finishes before the cassette Recording continues. Press [L/c STOP/EJECT] to stop it. If the cassette finishes before the CD The CD continues playing. Press [L] to stop it. Erasure prevention Use a screwdriver or similar object to break out the tab. Side A
Leader tape (Recording cannot be made.)
1
3
Tab for Side B
Tab for Side A
1
Press [L/c STOP/EJECT] to open the deck and load a cassette.
Close deck by hand. Side to be recorded facing you
Exposed tape facing upward
To re-record on a protected cassette Cover the hole with adhesive tape. To erase a tape Adhesive tape 1. Set [ ] to �TAPE/ �. 2. Insert the cassette with the side to be erased facing towards you and the exposed tape facing up. 3. Press [[ ]. [/ PLAY] is depressed at the same time. Note Noise may be recorded if this unit is near a TV. Keep the units at least 1.5 meters apart. Changes to volume and sound quality do not affect recording. To prevent interruptions to recording, supply AC power to the unit or replace the batteries. Your attention is drawn to the fact that recording pre-recorded tapes or discs or other published or broadcast material may infringe copyright laws.
2
Select the source to be recorded.
When recording radio broadcasts Tune in the station. (Do steps 1�4 of �Normal tuning� on page 3.) When recording CDs Insert the CD to be recorded. (Do steps 1�3 of �Normal play� on page 4.) If you want to record programmed tracks, program desired tracks before proceeding to step 3.
5
RQT6744
�
�
�
�
�
�
�
�
�
�
�
�
�
�
�
�
�
�
�
�
�
�
�
�
�
�
�
�
�
�
�
�
�
�
�
�
�
�
�
�
�
�
�
�
�
�
�
�
�
�
�
�
�
�
�
�
�
�
�
�
�
�
�
�
�
�
�
�
�
�
�
�
�
�
�
�
�
�
�
�
�
�
�
�
�
�
�
�
�
�
�
�
�
�
�
�
�
�
�
�
�
�
�
�
�
�
�
�
�
�
�
�
�
�
�
�
�
�
�
�
�
�
�
�
1 2
�
Switch [
] to �TAPE/S�.
Note � The unit is on in the pause mode. Stop tape to turn the unit off by pressing [L/c STOP/EJECT] when leaving the unit. � Do not press [/ PLAY] when rewinding or fast-forwarding, as this may jam the tape. Be sure to press [L/c STOP/EJECT] before the next operation. Full auto-stop The automatic stop system will release the buttons when the tape reaches the end during play, recording, fast forwarding or rewinding.
