|
Dla tego produktu nie napisano jeszcze recenzji!
 ;
Wszystko w porządku.
Instrukcja czytelna i kompletna.
Dziękuję.
all right!
thank you.
;
Bardzo dobra instrukcja. Zawiera wszystko co potrzeba, polecam!
 ;
Instrukcja jest OK. Schematy czytelne, opisane niektóre procedury.
;
Instrukcja bardzo czytelna. zawiera co potrzeba. Polecam
;
...instrukcja serwisowa w pełni czytelna i kompletna. Dziękuję!
RX-DV5SL
Removing the amplifier board (See Fig.11, 12)
Prior to performing the following procedures, remove the top cover and rear panel. 1. Disconnect the wire from the connector CN201 on the amplifier board. 2. Disconnect the amplifier board from the connector CN212 on the main board. 3. Disconnect the amplifier board from the wire connected to the connector CN231 and CN241 on the main board on the fan bracket. 4. Disconnect the screws marked G attaching the earth wire and the amplifier board. 5. Disconnect the four screws H attaching the amplifier board on the body. Fig.11
Tie band CN201
G H
CN212 DSP board
CN231 CN241 Amplifier board
CN212 CN231 CN241 Main board
Fig.12
Removing the power ICs (See Fig.13, 14)
Prior to performing the following procedures, remove the top cover, the rear panel and amplifier board. 1. Remove the six screws marked I attaching the power ICs. 2. Unsolder the two power ICs solder points attaching the rear side of the amplifier board. 3. Pull out the amplifier board from the bracket hooks on the heat sink.
Heat sink
Power ICs
I
I
Amplifier board
Fig.13
Power ICs solder points
Fook
Fook
Heat sink Amplifier board rear side
Fig.14
1-7
|
