JVC RX-E100SLC
Instrukcja Obsługi

Getting Started

Connecting the Speakers
After connecting the front, center, rear speakers and/or a subwoofer, set the speaker setting information properly to obtain the best possible DSP effect. For details, see page 12. CAUTION:
Use speakers with the SPEAKER IMPEDANCE indicated by the speaker terminals.

Speaker Layout Diagram

·
Connecting the front, center, and rear speakers

ª

1

2

3

Right rear speaker

For each speaker, connect the (+) and (�) terminals on the rear panel to the (+) and (�) terminals marked on the speakers respectively.

1 Cut, twist and remove the insulation at the end of each speaker cord (not supplied). 2 Open the terminal, then insert the speaker cord. 3 Close the terminal.
Connecting the subwoofer
By connecting a subwoofer, you can enhance the bass or reproduce the original LFE signals recorded in the digital software.

·
Powered subwoofer (example)
SUBWOOFER OUT

ª

INPUT

HIGH IMPEDANCE

Connect the input jack of a powered subwoofer to the SUBWOOFER OUT jack on the rear panel, using a cable with RCA pin plugs (not supplied). � Refer also to the manual supplied for your subwoofer. Since bass sound is non-directional, you can place a subwoofer wherever you like. Normally place it in front of you.

4