Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 4 (kliknij aby zobaczyć)
Installation
The refrigerator should be located away from direct sunlight and heat sources such as registers, radiators or any cooking products. In accordance with ISO standards, your refrigerator is performance rated at Class N, 16°C to 32°C (61°F to 90°F) or at Class ST, 18°C to 38°C (65°F to 100°F). Internal temperatures may be affected by such factors as its location, ambient temperature, and the frequency of door openings. Allow space around the unit for good air circulation. Allow a 25mm (1 inch) space behind and a 10mm (3/8 inch) space above the refrigerator for adequate ventilation. In a recessed installation, allow an extra 10 - 15 mm (½ inch) on each side for ease of installation. If the side of the unit will be placed against a wall, allow 13 mm (½ inch) space for proper door opening.
Installation
TO ADJUST THE FRONT ROLLERS
1. Open both doors. 2. Remove the toe grille by pulling it straight out. 3. Adjust the rollers by turning each roller adjusting bolt with a wrench until the refrigerator is level and stable. The rear rollers are not adjustable. 4. Check both doors to ensure that the seals touch the cabinet on all sides. 5. Replace the toe grille by lining up the retainers with the holes and pushing the grille straight on.
TIPS:
� If the freezer door is higher than the refrigerator door, raise the right corner and/or lower the left corner until the doors align across the top of the cabinet. � If the refrigerator door is higher than the freezer door, raise the left corner and/or lower the right corner until doors align across the top of the cabinet.
TIPS:
� Proper air circulation and leveling will assure efficient operation of your refrigerator. Do not use an extension cord. If refrigerator has an ice maker, locate it near a water supply. Remove all packing materials and tape. Wash interior with a mild soap and warm water. Do not use a razor blade or knife to remove tape.
