MARANTZ SA1
Instrukcja Serwisowa

How to remove the loading motor (See Fig. 2-1.) 1. Remove the lift lever. 2. Remove the screws (A1) x 4 pcs., to remove the gear cover. 3. Remove the screws (A2) x 2 pcs., to remove the loading motor.

(Adjusting the SACD mechanism completed products) It is necessary to position the spindle motor, the sub-shaft (mechanism), and the pickup to play a nonstandardized SACD disc. If the pickup or motor is replaced at the service division, these adjustments cannot be performed because of the facility and measuring equipment matters. The SACD mechanism completed products are adjusted for the above reasons. After installing: After installing the SACD mechanism completed product, remove the two solders shown below.(See Fig. 2-2.) [REMARK] � The two solders are used to eliminate static electricity before installing the SACD mechanism completed product.

Lift Cover

Loading Motor

(A2) x2 ø1.7x2mm Gear Cover
Remove these two solders after installing the SACD mechanism completed product.

(A1) x4 ø2x5mm

Figure 2-1

Figure 2-2

2-3