OPERATION
* In this instruction manual, some operations can only be performed with the remote control. For operations that can be performed with buttons both on the main unit and on the remote control, the button names are shown in the mark. And for operations that can only be performed with buttons on the remote control, the button names are shown in the mark.
CONNECTING THE POWER SUPPLY
1 Plug the power cable into AC IN jack on the back panel.
NORMAL PLAYBACK 7 Super Audio CD player playback
OPEN/ CLOSE
SUPER AUDIO CD PLAYER SA-15S1 PLAY
DISPLAY OFF STOP
SOUND MODE
POWER ON/OFF
PHONES
LEVEL
PAUSE
-
+
A
C
IN
w, e
q
r
q Press POWER switch to turn on.
LCD
2 Turn on the power switch of the audio unit (amplifier, etc.) 3
that is connected with this unit. Set the selector on the connected unit to this unit. Plug the power cable into an AC outlet. The display cycles from TOC Reading � No Disc (when no disc is loaded) � Super Audio CD (when the start sound mode setting is Super Audio CD).
w Press the
OPEN/CLOSE
button
The disc tray comes out. Place the disc with label side up on the tray. To play a single (8cm) CD, place the disc with the indentation at the center of the tray.
e Press r Press
OPEN/CLOSE
PLAY
button.
ENGLISH
Seconds
button.
Disc type is automatically detected and playback is started. Track number and track elapsed time(minute, second) appear on the display. * For Super Audio CD/CD hybrid-layer discs (See page 2), the layer that is set in the start sound mode (See page 13) is played. To change the layer, use the SOUND MODE button. (See page 12) (Exp.:Track 6, Elapsed time 2 min 8 sec)
Number of current track Minutes
Remaining track numbers
Playback automatically stops at the end of the final track.
