PANASONIC SADP1
Instrukcja Obsługi

The play timer
This timer starts play of the selected source at the selected time. Preparation Turn the unit on and set the time (� page 11).

To enjoy the desired source after the timer setting is completed 1 Turn the unit on and play the desired source. 2 After playing, turn the unit off. Even if you change the volume and source, the timer will start in these preset conditions. If you select �AUX� as the source Set the connected equipment�s timer to the same time. (See the instruction manual that came with the equipment.)

1

Press [CLOCK/TIMER] to select �FPLAY�.

The sleep timer
This timer turns the unit off after a set time.

PLAY
Each time you press the button: Clock )FPLAY )Original display

^________b

Press [SHIFT]r[SLEEP] to select the time (minutes).

2

Within 8 seconds

SLEEP

30

1 Press [:,X] or [9,W] to select the start time.

Each time you press the button: SLEEP 30_--)SLEEP 60_--)SLEEP 90 ^-=SLEEP OFF(=SLEEP 120(_} To cancel the timer Press [SLEEP] to select �SLEEP OFF�. To check the SLEEP setting Press [SLEEP] once. The remaining time appears. To change the setting Press [SLEEP] to display the remaining time, then press again to select the required time.

ON

AM 6:30

2 Press [CLOCK/TIMER] or [ENTER].

3

1 Press [:,X] or [9,W] to select the finish time.

OFF

AM 7:40

2 Press [CLOCK/TIMER] or [ENTER].

[Note]
The sleep timer can be used in combination with the play timer. The sleep timer always has priority. Be sure not to overlap timer settings.

4

1 Play the desired source.
To play an external source � page 33 To set only your favorite tracks/chapters Start program play (� page 16).

Using headphones

1

2 Adjust the volume.
When playing a disc, press [�] to stop play before step 5.

Reduce the volume and connect the headphones (not included).
Headphone plug type: 3.5 mm (1/8z) stereo

5

Press [FPLAY].

VOLUME
AC IN

TIMER PLAY
POWER

ADVANCED SURROUND
/ /

-DEMO

DVD/CD

TUNER/AUX

VOLUME DOWN UP

6

Press [�] to turn the unit off.

�/ I

OPEN/CLOSE PHONES

The timer starts at the set time with the volume increasing gradually to the set level. To cancel Press [FPLAY] to clear �FPLAY�. The timer comes on at the set time everyday if the timer is on. To check settings (While the unit is off) Press [CLOCK/TIMER]. The settings are displayed in the following order: Start time )Finish time )Source )Volume (While the unit is on) Press [CLOCK/TIMER] until �FPLAY� appears on the display. The start and finish times are displayed. To change the settings 1 Turn the unit on and press [FPLAY] to clear �FPLAY�. 2 Do steps 1�6 again.

2
Adjust headphone volume with [VOLUME].
Audio is automatically switched to stereo (2-channel).

[Note]
Avoid listening for prolonged periods of time to prevent hearing damage.
RQT6815

29

functionsOther