How to Attach
First, set the ID of the hard disk drive to �SLAVE.� Refer to the instructions on how to set the ID shown on the top (side with the model-name label affixed) of the hard disk drive.
3.
Fix the SA-K51U in place by inserting the screws (black) into the four screw holes of the stand and tightening them while the connector part of the SA-K51U is positioned so that it is faces the rear panel of the VR-510U. * Keep the screws straight and steady when tightening them because the stand has non-threaded screw holes.
1.
Fix the SA-K51U in place by inserting the screws (silver) into the four screw holes of the stand and tightening them.
Stand
Fix in place so as the flap and the hard disk drive�s connectors are on opposite sides. Connector part SA-K51U
2.
Open the cover of the VR-510U and remove the clamp from the power cable for the hard disk.
4.
Connect the hard disk power cable and flat cable to the connectors on the SA-K51U.
