|
|
|
Kategorie
|
|
Informacje
|
|
Polecamy
|
|
|
 |
|
|
Dla tego produktu nie napisano jeszcze recenzji!
WALL-MOUNTING THE SATELLITE
The TSS-450 satellite is designed to be mounted on the wall. There is a wall bracket for each satellite speaker. Each speaker bracket will require (4) 1-1/2," #10 wood screws; each screw should be fastened to a wall stud. If a wall stud is unavailable, install an anchor appropriate for a 1-1/2," #10 screw. NOTE: The customer is responsible for the correct selection and use of mounting hardware (available through hardware stores) that will ensure the proper and safe wall-mounting of the speakers. Step 1. Mark the positions on the wall where you would like to place the mounting screws. Step 2. Place bracket against wall and fasten four 1-1/2," #10 wood screws through the bracket�s screw holes into the wall. If a wall stud is not available, use an appropriate anchor. Step 3. Screw the post of the bracket into the 1/4"-20 threaded insert on the back of the satellite. Adjust the satellite to the desired angle and tighten the knob using the enclosed metal bar. keyhole on the back of the speaker to the screwhead on the wall. Figure 4. Once positioned properly, the speaker should slide down slightly and become secure.
Metal bar
SPEAKER CONNECTIONS
Turn Off All Power
First, turn off all audio-system power. Use high-quality speaker wire to make your connections. #18-Gauge speaker wire with polarity coding is recommended. For longer distances, #16-gauge or heavier wire is recommended.The side of the wire with a ridge or other coding is usually considered positive polarity (i.e., +). Also, consult the owner�s manuals that were included with your amplifier or receiver to confirm connection procedures. Observe polarities when making speaker connections, as shown in Figure 5. Connect each + terminal on the back of the amplifier or receiver to the respective + (red) terminal on each speaker. Connect the � (black) terminals in the same way.
Important!
Do not reverse polarities (i.e., + to � or � to +) when making connections. Doing so will cause poor imaging and diminished bass response. Be certain that positive and negative wire strands are completely isolated to avoid short circuits that may damage your equipment.
Insert Bare End; Release Tab
Press Tab and Hold
�
®
+
Bracket on wall.
Figure 5. Wiring diagram shows polarity connections for one channel of a home theater system.
SAT-450
5
|
|
|
> |
|
