PANASONIC SCEN26
Instrukcja Obsługi

Radio operations
Radio stations can be tuned manually by selecting the station�s frequency or they can be preset into channels to make it easy to tune. You can preset up to 20 FM channels and up to 12 AM channels.
OPEN/ CLOSE

DISPLAY SLEEP

1 4 7

2 5 8 0

3 6 9
= >10

To adjust the volume

CLOCK/ TIMER ADJ TIMER SET/CHECK

Input using the numbered buttons To select a 2-digit number
e.g. 11: [ 10] � [1] � [1]

PGM/CLEAR -AUTO PRESET

0
(Minimum)

50
(Maximum)

MUSIC PORT
TUNER/ BAND

CD

To adjust the volume
VOL
SOUND LIVE PLAY EQ VIRTUALIZER MODE

VOL

SC-EN27 SC-EN25/SC-EN26
u ALBUM i

PRESET TUNE

ALBUM

Allocation settings
Each country allocates broadcast bands according to their particular system. You can change the FM step. The step is factory-set to 0.2 MHz, but you can change it to receive broadcasts allocated 0.1-MHz steps. Any FM frequencies preset in channels will be changed by this procedure. Preset them again.

Auto tuning

Main unit

Select �FM� or �AM� Remote control
TUNER/ BAND

Press and hold until the frequency starts changing rapidly

3
u

4
i

Select �FM� or �AM� 1. Select the AM band with [TUNER/BAND]. 2. Press and hold [TUNER/BAND] on the unit. After a few seconds the display changes to show the current minimum frequency. Continue to hold the button down. The minimum frequency changes and the step is changed. To return to the original step, repeat the above steps. Note The preset memory will be initialized when you change the frequency step.

Press and hold until the frequency starts changing rapidly

� Auto tuning stops when it �nds a station. � To cancel auto tuning press the same button again. Note � Auto tuning may not function when there is excessive interference. Perform once for FM stations and once for AM stations.

To improve reception
FM AM

Automatic presetting
The tuner presets the stations it can receive into channels in ascending order.

TUNER/ BAND

Select �FM� or �AM� Note

Press and hold until �AUTO� appears

During automatic presetting, the memory indicator ( PGM ) �ashes and the frequency scrolls. The memory indicator and channel numbers are displayed for a second when a station is preset. The �rst station to be preset is displayed when presetting �nishes.

Receive the radio stations after connecting the antenna. Then attach the antenna code on the wall or pillar in the good reception. Change the direction and location of the antenna.

Manual presetting
Preset the stations one at a time.

Tune to the signal you want to set as the preset.

Within 10 seconds
4 1 5 2 3 6

7

8 0

9
>10 =

Enter preset mode
PGM

If noise is excessive in FM
You can improve FM reception by switching reception to monaural.
MONO

Select a channel

Note The station occupying a channel is erased if another station is preset over that channel. SC-EN27 SC-EN25/SC-EN26

Press to turn the MONO mode ON/OFF

Manual tuning

Main unit

Selecting channels
Select �FM� or �AM�

Select a channel

Select �FM� or �AM� Remote control
TUNER/ BAND

Select the frequency

3
u

4
i

Select �FM� or �AM�

Select a channel

Select �FM� or �AM�

Select the frequency

4