Other useful functions
SHIFT
TEST CH SELECT
Speaker level adjustments
SHIFT
SLEEP QUICK OSD
Sleep timer
This is one of the ways to get appropriate surround effects. Preparation Press [DVD/CD].
Press [SHIFT]i[SLEEP] to select the time (in minutes).
SLEEP 30_----)SLEEP 60_----)SLEEP 90 ^""""" OFF(_ SLEEP 120(__}
SLEEP
1
While stopped and no on-screen display is shown
Press [SHIFT]i[TEST] to output a test signal.
L: Front left C: Center R: Front right RS: Right surround LS: Left surround �There is no output from SW (subwoofer) channel. To cancel the timer Press [SHIFT]i[SLEEP] to select �OFF�. To confirm the remaining time Press [SHIFT]i[SLEEP] again. To change the setting Repeat the procedure from the beginning.
2 3
Press [VOLUME, r] or [s] to set the volume level normally used for listening. Press [3] (increase) or [4] (decrease) to adjust the speaker level for each speaker.
C, RS, LS: `6 dB to i6 dB (L, R: Only the balance is adjustable.) �To adjust the balance of the front speakers While outputting the test signal, press [2, 1]. �Adjust the speaker level to the same level as the front speakers.
SETUP MUTING
Muting
Press [MUTING].
�MUTING� flashes on the unit�s display.
To stop the test signal Press [SHIFT]i[TEST] again.
� To adjust speaker level during play
(Effective when playing multi-channel audio or when Dolby Pro Logic II or Super Surround is on.)
C
1
Press [CH SELECT] to select the speaker.
L #C #R #RS #LS #SW ^-------------------------------------------------} SW: Subwoofer �You can adjust SW only if the disc includes a subwoofer channel. ��SW� does not appear on the display and is not adjustable when Dolby Pro Logic II is turned on. ��S� appears on the display when �MUSIC� or �MOVIE� is selected with Super Surround (� page 22). In this case, you can adjust both surround speaker levels at the same time using [3, 4]. S: `6 dB to i6 dB
To cancel �Press [MUTING] again or reduce the volume to minimum (-- -- dB), then raise it to the required level. �Muting is canceled when you switch the unit to standby.
Using headphones
Main unit only
1
Reduce the volume and connect the headphones (not included).
Headphone plug type: 3.5 mm (1/8z) stereo
2
Press [3] (increase) or [4] (decrease) to adjust the speaker level for each speaker.
POWER
VOLUME
AC IN
C, RS, LS, SW: `6 dB to i6 dB (L, R: Only the balance is adjustable.) �To adjust the balance of the front speakers While �L� or �R� is selected, press [2, 1].
OPEN CLOSE DISC CHANGE DISC DISC CHECK
VOLUME
TUNE MODE
FM MODE
MEMORY
TUNING
DOWN
UP
SELECTOR PROGRESSIVE CD MODE
PHONES
1
2
3
4
5
2
[Note]
Adjust headphone volume with [VOLUME].
�Audio is automatically switched to stereo (2-channel).
Avoid listening for prolonged periods of time to prevent hearing damage.
RQT7969
23
functionsusefulquality/OthersoundandfieldSound
