Other speaker setup options
Attaching to a wall
�The wall or pillar on which the speakers are to be attached should be capable of supporting 10 kg (22 Ib.) per screw. Consult a qualified building contractor when attaching the speakers to wall. Improper attachment may result in damage to the wall and speakers. �Do not attempt to attach these speakers to walls using methods other than those described in this manual.
Optional connections
Listening to an external source/ Recording to other equipment
Audio cable (not included) White (L) Red (R)
[Note]
1
Drive a screw (not included) into a wall.
30�35 mm (13/16q�13/8q) �7.5�9.4 mm (19/64q� 3/8q) Wall or pillar 8�11 mm (3/8q� 7/16q)
RF IN
75
Y
DVD
VIDEO OUT
DVD/ VCR
VIDEO IN
EXT
A
FM ANT
PB/CB
RF OUT
LOOP ANT GND
L
LOOP EXT
AM ANT
PR/CR
COMPONENT VIDEO OUT
S-VIDEO OUT
LINE OUT
LINE IN
R
A
B
2
Fit the speaker securely onto the screw(s) with the hole(s).
Center speaker
Front and surround speakers
L R REC IN
150 mm (529/32q)
PLAY OUT
[A] You can record sound from discs, video cassette tapes, or radio, etc., to a tape deck.
1 Discs Press [DVD/VHS] to select �DVD/CD� as the source.
So that the speaker fits up against the wall squarely, be sure to press the speaker cable down into the groove.
Video cassette tapes Press [DVD/VHS] to select �VHS� as the source. Radio Press [FM/AM] to select �FM� or �AM�.
In this position, the speaker will likely fall if moved to the left or right. Move the speaker so the screw is in this position.
2 Start recording and play. Refer to the manual of the other unit for details.
[B] You can playback the sound from a tape deck/laser disc player, etc., through this unit�s speakers.
1 Press [VHS] to put the remote control in VHS mode. 2 Press [DVD/VHS] to select �VHS� as the source. 3 Press [W CH] or [X CH] to select �AU� channel. 4 Start play. When connecting a record player We recommend using a record player with a built-in phono equalizer. If your player doesn�t have a built-in equalizer, connect it first to a separate equalizer and then to the unit.
Fitting speaker stands (not included)
Ensure the stands meet these conditions before purchasing them. Observe the diameter and length of the screws and the distance between screws as shown in the diagram. �The stands must be able to support over 10 kg (22 lb.). �The stands must be stable even if the speakers are in a high position. e.g. Front and surround speaker 5 mm (13/64q), pitch 0.8 mm (1/32q) 60 mm (223/64q)
Speaker stand (not included) Attach the stands with these holes. Plate thickness plus 7 to 10 mm (plus 9/32q to 25/64q)
RQT7388
