TOSHIBA SD2150
Instrukcja Serwisowa

Cam

1-3-3. Loading Motor <Removal> 1. Remove the loading belt. (Refer to item 1-3-2.) 2. Remove two screws (1). 3. Remove four screws (2) and remove the loading motor (3) (with the loading motor PC board (4) attached). 4. Desolder the terminal part of the loading motor (3) and remove the loading motor PC board (4). 5. Replace the loading motor (3).
Second tray 2 Chassis
P

POM mark position

Screws (1)
Eject

Fig. 2-1-14 2. Solder the terminals of the loading motor (3) on the loading motor PC board (4) . 3. Since the switch of SW3 comes over the external peripheral portion of the cam, push the switch by inserting a spacer to the clearance between the chassis and the loading motor PC board (4). (Refer to Fig. A.) 4. With the loading motor PC board (4) held, tighten two screws (2)-1 on the loading motor (3) side and then fix two screws (2)-2.
Loading motor (3) SW2 Loading motor PC board (4) SW1 SW3 Screws (2)

5. Tighten two screws (1). 6. Mount the loading belt. 7. Close the second tray 2 .
Fig. A Loading motor PC board (4) Spacer Screws (2)-2 Screws (2)-1 Loading motor PC board (4)
O M

Fig. 2-1-13

Push Cam Chassis

SW3

<Mounting> 1. Eject the second tray 2 . (Set the POM mark of the cam to the position as shown in Fig. 2-1-14.)
Cam SW3 SW3

Loading motor (3)

Cam Chassis Second tray 2

Screws (1)

Fig. 2-1-15