TOSHIBA SD-510EE
Instrukcja Serwisowa

Tray (3)

B

� Confirm that the mark of the gear matches with the triangle mark on the reverse side of the tray in the tray close status. (The gear is rotated with the slider locks.) (Refer to Fig. B.)
Fig. A

Tray panel (4)

A

Gear (4)

Triangle mark

Tray (3)

Claws

Tray panel (4)
Position of the line Pickup mechanism assembly Gear (4)

Fig. 2-1-5 1-1-4. Front Panel and Tray 1. Remove the flexible cable (1). 2. Remove one screw (2) and remove the GND lead (5). 3. Release four claws and remove the front panel (4). 4. Pull out the tray (3) to this side.
Screw (2) GND lead (3)

Tray rack gear

Slider

Tray (3)

Marking

Triangle mark

Gear (4)

Claw
Fig. B

Tray (5)

Fig. 2-1-7 1-1-5. Rear Panel 1. Remove twelve screws (1) and remove the rear panel (2).

Front panel (4) Flexible cable (1) Claws

Screws (1)

Fig. 2-1-6 Note: � Insert the tray (3) with the front side of the pickup mechanism assembly descended. (The slider positions to the left side.) � The gears are required to match their phases each other. After setting the gear (4) as shown in the figure �A�, insert the tray (3). When inserting a tray (3), push the rack gear side shown by the arrow. Fig. 2-1-8

Rear panel (2)