SHARP SDEX100H
Instrukcja Obsługi

SD-EX100H

ENGLISH

� Using the Auto Station Programme Memory (ASPM)
Whilst in the ASPM operation mode, the tuner will automatically search for new RDS stations. Up to 40 stations can be stored. If you have already stored some stations in memory, the number of new stations you can store will be less.

To stop the ASPM operation before it is complete:
Press the ASPM button whilst it is scanning for stations. The stations which are already stored in memory will be kept there.

Notes:
z If the same station is broadcasting on different frequencies, the strongest frequency will be stored in memory. z Any station which has the same frequency as one stored in memory will not be stored. z If 40 stations have already been stored in memory, the scan will be aborted. If you want to redo the ASPM operation, erase the preset memory. z If the RDS signals are very weak, station names may not be stored in memory.

1

Press the TUNER (BAND) button to select the FM band.

To erase all of the contents of preset memory:

2

Press and hold down the RDS ASPM button for at least 3 seconds.

1 2

Unplug the unit.

Whilst holding down the ON/STAND-BY button, plug in the AC power lead.

Press down the ON/STAND-BY button until "RESET" is displayed. 3 1 After "ASPM" has flashed for about 4 seconds, scanning will start (87.50 108.00 MHz). Press the ON/STAND-BY button again to turn the power on.

Caution:

To store a station name again if the wrong name was stored in memory:
2 When an RDS station is found, "RDS" will appear for a short time and the station will be stored in memory.

RDS Radio

This operation will erase all data stored in memory including clock, timer settings, tuner preset, and CD programme.

1 2 3
Using the Radio Data System (RDS) -

It may be impossible to store station names in memory using the ASPM function if there is lots of noise or if the signal is too weak. In this case, perform as follows. 1 Press the TUNER PRESET ( or ) button to check whether the names are correct. 2 If you find a wrong name during receiving the station. Wait until the correct name will be displayed. And then press the ENTER button. 3 Within 5 seconds, press the TUNER PRESET ( or ) button to display the preset channel to be corrected again. 4 Within 5 seconds, press the ENTER button. z The new station name has been stored in memory correctly.

3

After scanning, the number of stations stored in memory will be displayed for 4 seconds, and then "END" will appear for 4 seconds.

4 5 6 7 8
E-20

Notes:

z The same station name can be stored in different channels. z In a certain area or during certain time periods, the station names may temporarily be different.

02/4/17

e3.fm