jedyne do czego mogę mieć zastrzeżenie to jakość zdjęć zawartych w przesłanej instrukcji serwisowej ponieważ są fatalnej jakości, praktycznie nieczytelne. tak poza tym jestem zadowolony to jest to czego szukałem.
Instrukcja jest OK. Schematy czytelne, opisane niektóre procedury.
Tekstowy podgląd strony 8 (kliknij aby zobaczyć)
2. Caution in Replacing Parts
Check whether or not the DVD drive, 42-pin FFC and the main board are connected properly after replacing the DVD drive or the main board. Then, remove the pick protective solder (two points.) Before replacing the DVD drive or the main board, be sure to solder on the DVD drive to prevent damage by static electricity.
Pick protective solder
Solder the harness connecting from the DVD drive on the edge of the main board as the figure shown below after replacing the DVD drive or the main board. If not, reassembling can not be performed properly due to interference between parts.
Land for soldering
The harness connecting from the DVD drive
When replacing PJ705, cut the connector end on the back of the board within 1mm after soldering. If not, reassembling can not be performed properly due to interference between parts.
Cut the connector end. Within 1mm
When replacing the label, be sure to fill in the serial number and stick the seal on the label for protection.
