Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 6 (kliknij aby zobaczyć)
EN
Connection to TV
fig.7
Connections to your TV
As previously noted the amplifier (Power Injector + Power supply) must be placed in-line between the aerial and before any splitter or additional devices. 1. Connect the coaxial cable from the aerial to the connector labeled AMP on the Power Injector. 2. Connect Power Injector to the aerial input on your TV, Digital Set-Top box, Splitter and / or any other device. Note � some set-top boxes require an �F� type connector � use the adapter supplied. 3. Connect the Power Supply DC plug to the Power Injector then plug the power supply adapter into a 230 Volt AC receptacle. Safety Note -The power injector and power supply is for indoor use only! A note about coaxial cable - Your SDV2940/05 includes a 6m roll of RG-59 coaxial cable. If this is not adequate for your needs we recommend for best possible signal integrity that you do not extend this cable.A better choice is to replace the cable with either RG-6 or RG-6 Quad Shield cable. Both of these cables are designed for minimal signal loss over longer cable runs. This will ensure the best possible picture and overall performance.
Warranty
Warranty information can be found at: www.philips.com/guarantee