|
|
|
Kto jest w sklepie?
Sklep przegląda 5591 gości |
|
Kategorie
|
|
Informacje
|
|
Polecamy
|
|
|
 |
|
|
Dla tego produktu nie napisano jeszcze recenzji!
 ;
Dokładna dokumentacja, pomogła w szybkiej naprawie telewizora. Dziękuję!
 ;
jedyne do czego mogę mieć zastrzeżenie to jakość zdjęć zawartych w przesłanej instrukcji serwisowej ponieważ są fatalnej jakości, praktycznie nieczytelne. tak poza tym jestem zadowolony to jest to czego szukałem.
;
Wszystko w porządku.
Instrukcja czytelna i kompletna.
Dziękuję.
all right!
thank you.
;
Bardzo dobra instrukcja. Zawiera wszystko co potrzeba, polecam!
;
Instrukcja jest OK. Schematy czytelne, opisane niektóre procedury.
2 If the parallelism of the mirror base B is improper as shown in the
figure below (one side of the mirror base B is in contact with the positioning plate and the other side is not in contact), perform the following procedure.
2
3
3 Loosen the mirror base drive pulley fixing screw on the side where
the mirror base B is not in contact with the positioning plate.
4 Manually rotate the mirror base drive pulley on the side where the
mirror base B is not in contact with the positioning plate to bring
4
3 Fix the mirror base wire to the pulley with the mirror base wire
fixing screw.
the mirror base B into contact with the positioning plate.
3
4 Return the 9th winding tip of the mirror base wire to the original
position. (Perform the same procedure for the front frame side and the rear frame side.) (Note) After replacing the mirror base drive wire, perform the vertical skew adjustment, the focus adjustment, and the horizontal skew adjustment.
3) No. 2/3 mirror unit (mirror base B) installation (Mirror base B positioning)
This is to adjust the parallelism of mirror base B and the drum surface and the original surface. This adjustment must be performed in the following cases:
� �
When the mirror base drive wire is replaced. When mirror base A or mirror base B is replaced. B in contact with the mirror base positioning plate. If the front side and the rear side of the mirror base B make contact with the mirror base positioning plate simultaneously, the parallelism of the mirror base B is proper, and there is no further adjustment.
1 Manually turn the mirror base drive pulley to bring the mirror base 5 Tighten the mirror base drive pulley fixing screw. 6 Manually rotate the mirror base drive pulley to separate the mirror
base B from the mirror base positioning plate once, then bring it into contact with the positioning plate. Check that the front side and the rear side of the mirror base B make contact with the positioning plate simultaneously.
Mirror base positioning plate
7 If the condition of 6 is not satisfied, repeat procedures 3 through 6 until the condition is satisfied.
No.2/3 mirror unit
6 � 10
 $4.99 SF-1120 SHARP
Schematy Zestaw schematów dla tego urządzenia. Plik PDF zawierający schematy będzie dostarczony na Twó…
|
|
|
> |
|
