jedyne do czego mogę mieć zastrzeżenie to jakość zdjęć zawartych w przesłanej instrukcji serwisowej ponieważ są fatalnej jakości, praktycznie nieczytelne. tak poza tym jestem zadowolony to jest to czego szukałem.
Bardzo dobra instrukcja. Zawiera wszystko co potrzeba, polecam!
Tekstowy podgląd strony 28 (kliknij aby zobaczyć)
3. Fuser section
3-1. Fuser unit removal
1 2 Open the front panel Remove the table glass.
8 Remove an E-ring and two connectors.
3 Turn the open/close lever to the right and open the upper unit slowly. 4 Remove the connectors (2 pin � 2), slightly lift the right side of the unit and pull it out.
3-2. Heater lamp replacement
1 Remove the fuser cover fixing screw (1 pc.), and slide it to the front side, and remove it. 2 While pushing the projection of the Faston terminal connected to the thermostat, remove the lead wire from the connected section. 5 Move the copy lamp unit to the left of the body (the paper exit side). 6 Disconnect the connector (2-pin) of the dehumidifier heater which extends from the dark box cover. Insert a long screwdriver (+) into that port and remove the screw which is fixing the fuser cover. 7 Remove the fuser cover in the direction of arrow A . 3 Remove the lamp holder fixing screw on the top of the rear frame, and remove the holder. 4 Pull out the heater lamp from the front frame. For assembly, reverse the disassembly procedures.
