SHARP SF2114
Instrukcja Serwisowa

3. Fuser section
3-1. Fuser unit removal
1 2 Open the front panel Remove the table glass.

8 Remove an E-ring and two connectors.

3 Turn the open/close lever to the right and open the upper unit slowly. 4 Remove the connectors (2 pin � 2), slightly lift the right side of the unit and pull it out.

3-2. Heater lamp replacement
1 Remove the fuser cover fixing screw (1 pc.), and slide it to the front side, and remove it. 2 While pushing the projection of the Faston terminal connected to the thermostat, remove the lead wire from the connected section. 5 Move the copy lamp unit to the left of the body (the paper exit side). 6 Disconnect the connector (2-pin) of the dehumidifier heater which extends from the dark box cover. Insert a long screwdriver (+) into that port and remove the screw which is fixing the fuser cover. 7 Remove the fuser cover in the direction of arrow A . 3 Remove the lamp holder fixing screw on the top of the rear frame, and remove the holder. 4 Pull out the heater lamp from the front frame. For assembly, reverse the disassembly procedures.

A

6�6