SHARP SF-2220
Instrukcja Serwisowa

[4] UNPACKING AND INSTALLATION
14. Optional multi paper feed unit (SF-MF15) installation

3 Insert the positioning pins of the multi paper feed unit into the installation holes of the copier. At that time, first insert the rear pins, then insert the front pins. (Check that the multi paper feed unit connecting pins are properly connected.) Then fix the multi paper feed unit with the two screws which were removed in procedure (2).

Rear side Positioning pin

Installation holes

Fixing screw

Disconnect the power plug of the copier and perform the following procedures.
1 Open the front cabinet of the copier and lift the upper unit slowly with the open/close lever.

Fixing screw Multi paper feed unit Positioning pin Front side
4 With the above procedure, the multi paper feed unit installation is completed. * Close the upper unit slowly and close the front cabinet. The multi paper feed unit mode is automatically set.

Body open/close lever Upper unit

15. Personal counter (Service item)
1 Remove the upper cabinet left and the left cabinet.

Front cabinet
2 Remove two fixing screws of the right cabinet, and remove the right cabinet. The two removed screws are used for installation of the multi paper feed unit to the copier.

1)

Right cabinet lower

2)

4) 3)
Fixing screw

3)

* Keep the right cabinet, which is required when the multi paper feed unit is removed. 4 � 12