ADJUSTING THE OVEN TEMPERATURE CONTROL
Although your new oven is properly adjusted to provide accurate temperatures, it may cook faster or slower than your old oven. If you are not satisfied with the baking/roasting results, you can change the temperature calibration by following the steps below. NOTE: DO NOT measure the oven temperature with a thermometer. Opening the oven door will lower the oven temperature and give you an incorrect reading. Also, the thermometer temperature reading will change as your oven cycles.
1. Make sure the oven temperature control knob is
turned to the off position. Pull the knob straight off and flip it over.
2. Loosen the locking screws inside the
control knob. Note the position of the notches.
Locking screws
1 NOTCH = 5�F 1 NOTCH = 5�F
Notches
G
COOLER
E
3. Adjust the temperature.
� To lower the temperature, hold the knob
handle firmly and turn the skirt clockwise to move the tooth a notch to the �E� on the �COOLER� arrow. � To raise the temperature, hold the knob handle firmly and turn the skirt counterclockwise to move the tooth a notch to the �E� on the �HOTTER� arrow. Each notch equals about 5°F. To raise Notches
G
OLER CO
Skirt Locking screws
4. Tighten the locking screws and replace the
control knob.
